Computer failures - Display -

xie2010091

[SIZE = 3] displays

Display in a long time, a variety of small problems will follow. Experts believe that,[link widoczny dla zalogowanych], to solve these little problems is actually very simple, with a pair of eyes can see the fault lies.

a common fault: just getting on the computer screen of machine shake so badly,[link widoczny dla zalogowanych], and sometimes even the icons and text are not clear, but after twelve minutes and then will return to normal.

this phenomenon occurred in wet weather, damp inside the monitor's sake. To solve this problem, use damp sand in the food packaging to string together with cotton thread, and then open the back cover of the monitor will hang in the damp sand near the end of the tube neck tube near the tube socket. Thus, even in wet weather, it will not appear above the \

Troubleshooting II: computer boots, the display is only heard and not seen the painting, dark. To wait several minutes to appear on the screen.
seat tube leakage is due to be replaced sockets. Open the back cover to see the end of the tube a small circuit board, sockets to solder on the circuit board. Carefully remove this circuit board, and then welded pipe under the seat, to the electronics store to buy back a seat the same tube, tube socket weld and then returned to the circuit board. Then install the board not to rush back to first find a small piece of sandpaper, very carefully, after the end of the tube protruding pin wipe clean with sandpaper. In particular, pay attention to pin on the oxide layer, if not clean polished soon relapse. The board back together and you're done.

three common faults: display screen,[link widoczny dla zalogowanych], there will always be lingering clutter interference or lines, and the speaker also has unwanted noise.

This phenomenon is mostly caused by poor power supply interference. If you too lazy to get involved, you can replace a new power supply. If there is enough ability, you can try to replace the power within their own filter capacitor, which often can be effective; if the result is less obvious, can be changed to switch off.

four common faults: display Huaping.

graphics on this issue is caused by more. If it is new for the graphics card, the card may be of poor quality or incompatible, then there is not yet installed the correct driver. If the old card and added memory,[link widoczny dla zalogowanych], then there may be new graphics and added to the original model parameters vary due to memory.

five common faults: display a black screen.

graphics card if it is damaged or broken monitors and other causes no signal sent to the display,[link widoczny dla zalogowanych], the display will stop flashing lights did not receive prompt signal. If the resolution is set too high, more than the maximum resolution the display will appear black, severe destruction of the monitor, but now the display has a protective function, when the resolution exceeds the set value is automatically protected. In addition,[link widoczny dla zalogowanych], conflicts can also cause black hardware. [/ SIZE] replace the power supply filter capacitor inside, which often can be effective; if the result is less obvious, can be changed to switch off.

				fora.pl - załóż własne forum dyskusyjne za darmo Powered by phpBB © 2001, 2002 phpBB Group Avalanche style by What Is Real © 2004